This was my first try mounting a video jack external to the TS1000, before I decided a bracket was better. This trial used two pieces of veroboard separated by two nylon standoffs sticky-taped to the TS1000 case.
You can see in the upper left, this is an ISS 3 ( Issue 3 ) version printed circuit board.
Adding double sticky tape to bottom of XZ8-CCB
ZX8-CCB Fastened in place with double side foam sticky tape. I prefer this orientation to the 180 degree rotated one.
This was my first try mounting a video jack external to the TS1000, before I decided a bracket was better. This trial used two pieces of veroboard separated by two nylon standoffs sticky-taped to the TS1000 case.
View of the bottom side of an ISSUE 1 PCB
Closeup view of the back of an ISSUE 1 PCB
View of a right-angle bracket with double-sided foam sticky tape that I used to mount a video jack on top side of a TS1000.
View of a right-angle bracket with double-sided foam sticky tape that I used to mount a video jack on top side of a TS1000.
